Audio/Visual

EEI Home

Visual Annunciators

Patient Stations

Emergency Stations

Accesories

Patient Protectores

Pocket Paging

Door Monitors

Wiring & Misc.

Contact EEI

900-362 Installation   Connect Power Supply (12vdc 500ma min.) to Power Terminal as shown. Connect Zone Alarm terminal to closed circuit device. If J1 is set in the remote reset-disarm position it is necessary to connect all unused alarm zones to - on power supply. Set Jumper J1 to desired position Local and remote Reset/Disarm short 1 and 2 Remote only Reset/Disarm short 2 and 3 Remote reset switch should be a normally open momentary type device. Use a maintained type switch for remote disarm. The remote signal terminal goes negative when the zone is in the alarm condition and may be used to operate a remote light or buzzer with a maximum of 200ma output. Adjust tone volume control to desired level.